Development of a short-term procedure for the evaluation of damage-relevant parameters of ferritic materials and components used in nuclear technology “EKusaP”
The overall objective of the research project is to develop a way to simplify the provision of fatigue data that can be used for both stress and strain-controlled loading situations. In add
SteBLife – A new method for the time- and cost-efficient provision of fatigue data for the safe design of cyclically stressed components and parts for plant and machine engineering
Abstract – The service life of materials and components is limited when they are subjected to repeated mechanical stresses, which is why an understanding of the damage
Introduction
Weight-optimized component design and the resulting estimation of the service life or service life of metallic materials require a comprehensive understanding of fatigue processes and the systematic investigation of fatigue behavior. For reasons of time and cost alone, many components can usually neither be built as prototypes nor tes
Experimental setup and material
The stress-controlled single-stage tests were carried out on a Shimadzu type EHF-U servo-hydraulic test system with a maximum load of 50 kN, a frequency of f = 5 Hz, a sinusoidal load-time function, and a load ratio of R = -1 at room temperature with RT = 25°C.
The specimens were stressed to failure or to reach th
A normalized unalloyed steel of grade C45E was used as the test material. The specimens were machined from round material with a length of 5,000 mm and a diameter of 20 mm and subsequently polished to a roughness value of Rz < 6 µm. The chemical composition according to the manufacturer's specifications corresponds to the specified limit value
During heat treatment, the unalloyed C45E was austenitized at T = 850°C and then cooled to RT in a controlled manner, resulting in a predominantly ferritic-pearlitic microstructure with a Vickers hardness of HV10 = 216 [4,5]. In the tensile test, the material reached a maximum strength of Rm = 710 MPa and exhibited a yield strength of Rp0.2
